AquaNaut 400 - 4-Wheel Drive, Pools up to 20' x 40' (Open Line)

Q: i have an aquanaut 400. I have 2 but one has the rear wheels not engaged with the grey spline gear; so not moving; all seems ok , not worn and not misaligneded. The good unit has the rear wheels turning by the inside wheel gears; where the faulty one has the grey spline gear in the center of the gears; not touching either. . Changing the grey spline shaft will not do anything as its normal, nor worn. Must be alignment but. all seems to be straight , in order. Allot of slop in the design to begin with for fitting any gears, splines.

Q: I need replacement tires for my Aquanaut 400 4 wheel drive. How can I obtain them?

Q: How to remove & replace vanes / rotor assembly? It seems I have to lift out main gear shaft but it doesn’t lift out easily and I don’t want to break it.

Q: I need replacement tires part numbers for the front and rear wheels for my AquaNaut 400 please.

Q: aquanaut 400 a parts list would be nice, a couple of your listed suppliers carry spare parts like the gears and shafts

Q: i have a new 4 wheeler and it gets stuck facing the wall because instead of turning left or right, it does a complete 360 degrees and most of the time ends up facing the same wall still.

Q: Of my two choices...the Aquanaut and the TracVac, which one will work better at higher flow and negative pressure from a high-HP VS pump? I may not always want to use high speed, but I cannot always guarantee the pump won't run at that speed.

Q: Does the Aquanaut 400 come with hoses? If not, how much are the hoses?

Q: My pump is working fine, but my Aquanaut 400 has stopped moving. I can't see any obstructions. What should I do?

Q: The gears on the turbine are broken. Can I get instructions on replacing the turbine?

Q: Is the AquaNaut 450 a successor model to the AquaNaut 400? In other words, are there any significant differences between the two models?

Q: What Hayward in ground pool is the best around pool run cleaner.

Q: What is the part number for the Aquanaut 400 tires?

Q: I have a 4-wheel version of your pool vacuum and have been very happy with it - until now. It is 3 years old and began to show signs of wear and was not able to maintain traction. I purchased the lower gear "kit" because some of the gears were worn (not missing) and I replaced the tires, which were beyond the wear marks. All the gears, the turbine, the tires have been replaced. However, when I put it in the pool I found that the wheels/tires turn quite nicely but the vacuum was not getting enough traction to move about the pool. I took all floats off the line except two that I kept at about 24 inches from the vacuum, per the manual's. There were two other floats that were also underwater that I removed, thinking they were "lifting" the unit sufficiently to cause slippage of the tires. No improvement. I increased and decreased suction using my VacMate lever, no change. I am at a loss. Can you help?

Q: I need to purchase the large orifice for a Howard aquanaut 400 cleaner